Lighting control: Basic - Stand Alone solution
The products of the basic - Stand Alone solution are suitable for every new service-sector room, from the smallest to the largest and can also be applied immediately in existing rooms o in restorations.
The offer is made up of combined movement and lighting sensors which manage the load in on-off.
Supplied at 230 V can control all the main types of lamp on the market.
Factory pre-adjustment gives immediate operation on first installation, while the availability of trimmers and remote controls means that the operation of the devices can be customised to satisfy the needs of every type of room.
MAIN FEATURES
The range includes:
-
Range of standard sensors
-
Range of advanced sensors
-
Sensors for indoor areas
-
Sensors for outdoor areas
-
Sensors for transit areas
-
Control of all types of lamps
-
230 Vac power supply
-
ON-OFF load management
STANDARD SENSORS: managing lighting in rooms without a contribution of natural light.
The basic sensors only measure the general lighting level once, when movement is detected for the first time. As long as a presence is detected, even if the measured lighting level becomes greater than the configured brightness threshold, the sensor will not switch the lighting off.
The devices of the basic - Stand Alone solution all use PIR passive infrared sensors, a detection technology based on pyrolectric sensors, which measure the variations of temperature in the room.
They are suitable to be used in rooms without natural light such as toilets, corridors, storage closets, technical rooms, etc.
The loads are activated/deactivated automatically on the basis of the movement detection. Management of a single load in on-off mode.
ADVANCED SENSORS: managing lighting in rooms with a contribution of natural light.
The advanced sensors measure the general lighting level continuously (not only the first time a presence is detected). If a presence is detected and if the lighting level measured becomes greater than the configured brightness threshold, the sensor will switch the lighting off.
The advanced sensors can use two technologies: PIR (Passive InfraRed) and US (UltraSound). They are used in rooms with natural light such as: individual or collective offices, open spaces and meeting rooms.
The loads are activated/deactivated manually (by command) or automatically on the basis of the presence detection or the lighting level.
On-off mode load management.