Livinglight

Smart devices are installed in normal boxes, with brackets and plates. Just remember:

• the connected devices must always be powered with Phase and Neutral;
• only one connected control is required for each switch: all the others can be traditional (two-way switches and inverters).
• traditional relay and pushbutton systems can be turned into Smart systems using the special connected relay, item 3584C.
• the installation of a Gateway device in a position of the home that can be reached by a good Wi-Fi signal from the router modem is required.

Smart devices are installed in normal boxes, with brackets and plates. Just remember:

• the connected devices must always be powered with Phase and Neutral;
• This requirement does not apply to the 2-module dimmer/switch, item L/N/NT4411CM2, which can easily replace a traditional switch, as it does not require the connection of the Neutral cable.
• only one connected control is required for each switch: all the others can be traditional (two-way switches and inverters).
• traditional relay and pushbutton systems can be turned into Smart systems using the special connected relay, item 3584C.
• the installation of a Gateway device in a position of the home that can be reached by a good Wi-Fi signal from the router modem is required.
   

It’s simple. Access the Smart Home Configurator in the Tools section of the site. With just a few clicks you can:

• create your home (one, two or three bedroom apartment, attic/home, penthouse/large villa)
• select systems (Motive power and services, lights, shutters, ...)
• customise the functions of each system for each room
• customise the ranges (Living Now, Livinglight, Axolute,…)
• customise the material list and get a complete estimate.

The estimate will remain saved in your personal area and will always be available to you.